+- KeexyBox's forum (https://forum.keexybox.org)
+-- Forum: System settings (https://forum.keexybox.org/Forum-System-settings)
+--- Forum: Network (https://forum.keexybox.org/Forum-Network)
+--- Thread: input output settings and dhcp (/Thread-input-output-settings-and-dhcp)
input output settings and dhcp - luke - 08-22-2021
Hi i have everything setting up on a pi 4, but having troubles setting up the input and the output network ips, how should i do the dhcp ips
RE: input output settings and dhcp - shak4031 - 08-30-2021
I had the same confusion, but the below worked for me. This is for using Keexybox as primary entry point for all devices (DNS/DHCP/Gateway).
1) set Input network to different subnet then your primary router.
ex. Router IP is 192.168.1.1
interface eth0 (for both input and output)
input to 192.168.2.254
output to 192.168.1.254
RE: input output settings and dhcp - benoit - 09-07-2021
Hi,
Let's say that your router has the IP 192.168.1.1/24 and it is a DNS server. Here is an example of configuration for your KeexyBox:
Input network (network that will reach your devices)
- Interface: eth0
- IP address: 192.168.2.254
- Netmask: 255.255.255.0
Output network (network that will reach your router)
- Interface: eth0
- IP address: 192.168.1.254
- Netmask: 255.255.255.0
DNS and Gateway
- Gateway: 192.168.1.1
- DNS 1: 192.168.1.1
- DNS 2: (Leave blank)
It is also recommended to disable DHCP on the router and enable it on Keexybox. Here is an example of DHCP configuration for your KeexyBox:
Address range for the network: 192.168.2.0/24
- Enable DHCP (checked)
- DHCP start IP: 192.168.2.151
- DHCP end IP: 192.168.2.201
Address range for the network: 192.168.1.0/24
- Enable DHCP (checked)
- DHCP start IP: 192.168.1.151
- DHCP end IP: 192.168.1.201
Reboot Keexybox when you are done.
I hope this will help.